Test & measure > Test sets

Keysight Technologies MXE EMI receiver

07 September, 2015

Keysight Technologies has added real-time spectrum analysis (RTSA) as an option for its standards-compliant MXE EMI receiver, enabling test labs to observe and diagnose transient and wideband emissions.


Keysight Technologies N6900 Series DC power supplies

04 September, 2015

Keysight Technologies has introduced four performance options for its Advanced Power System (APS) N6900 Series DC power supplies, boosting test-system versatility.


Keysight Technologies 5G Channel Sounding Reference Solution

27 August, 2015

Keysight Technologies has introduced its 5G Channel Sounding Reference Solution, which is designed for accelerating advanced research of millimetre-wave 5G channel models and includes ultrabroadband and MIMO — key requirements to measure the millimetre-wave channel and validate air interface standards.


Rohde & Schwarz NRP2 Power Meter & Voltmeter

25 August, 2015

The compact, robust Rohde & Schwarz NRP2 base unit with colour display supports up to four R&S NRP-Zxx or NRPxxS/SN power sensors and all sensor-dependent measurement functions.


Kikusui PLZ1003W Electronic Load

25 August, 2015

The Kikusui PLZ1003W Electronic Load has a 1000 W power rating with a voltage range of 1.5 to 120 V and current range from 0 to 200 A, and is used to simulate and carry out actual load tests on power supply units.


Fluke DSX-5000 Cable Analyser

18 August, 2015

The DSX-5000 Cable Analyser copper test solution enables testing and certification of twisted-pair cabling for up to 10 Gigabit Ethernet deployments, and will certify shielded and unshielded structured cabling systems from Category 3 to 6A and Class C to FA at Level V accuracy.


National Instruments Wireless Test System

11 August, 2015

The National Instruments Wireless Test System combines advances in PXI hardware to offer a single platform for multi-standard, multi-DUT and multi-port testing, which, when used with flexible test sequencing software, can significantly improve instrument utilisation when testing multiple devices in parallel.


Bird Channel Power Monitor

05 August, 2015

The Bird Channel Power Monitor from Vicom comprises a 1RU central processor and a variety of sensors that work together to monitor all components of a radio system, including each individual radio, the combiner, the feed lines and antenna.


Anritsu MT8821C Radio Communication Analyser with LTE-A support

04 August, 2015

The Anritsu MT8821C Radio Communication Analyser is an all-in-one RF tester with the capability for supporting LTE-A as well as all other adopted technologies.


Keysight E7515A UXM wireless test set

04 August, 2015

The enhanced Keysight Technologies E7515A UXM wireless test addresses leading-edge LTE-A carrier aggregation test requirements, with support for downlink 4CC1, 256 QAM, and LTE-U with up to three unlicensed carriers, as well as FDD-TDD mixed CA and uplink intra- and inter-band CA measurements.


FW Bell 5180 Gauss/Tesla Meter

03 August, 2015

The FW Bell 5180 Gauss/Tesla Meter is a magnetic measuring device with digital signal processing (DSP) that works in either sensitive laboratory environments or rugged industrial settings.


MegiQ 4 GHz PC-based VNA

03 July, 2015

The MegiQ VNA0440 from Emona Instruments is a fully bidirectional two-port VNA that enables detailed impedance measurements of antennas, components and circuits over a range of 400 to 4000 MHz.


FLIR Systems CM55/57 Flexible Clamp Meters

29 June, 2015

The FLIR Systems CM55/57 Flexible Clamp Meters and the TA72/74 Universal Flex Current Probe Accessories enable electricians to take accurate measurements in tight, awkward spots that are difficult to access with a traditional hard-jaw clamp meter.


Rohde & Schwarz FSWP phase noise analyser and VCO tester

21 May, 2015

The Rohde & Schwarz FSWP phase noise analyser and VCO tester enables ultrasensitive and ultrafast phase noise measurements, as well as measurements of pulsed sources and the residual phase noise of RF components.


Aeroflex 8800S digital radio test set

13 May, 2015

The Aeroflex 8800S expands upon the features of the 8800 series with P25 Phase II TDMA compatibility and higher direct input power handling of 125 W.


  • All content Copyright © 2025 Westwick-Farrow Pty Ltd